Products > Test Equipment
Who can provide TDS2024C EPROM firmware backup?
(1/4) > >>
lern01:
The EPROM firmware of one of my TDS2024C oscilloscopes is damaged. I hope that friends from the almighty EEVblog can provide me with a copy.Or the firmware of TDS2004C and 2014C will also work. Thank you very much!
Email:lern01@outlook.com
darkspr1te:
It's quite possible that no one has it or has access to it. Other reason could be that some users dont daily this site and you may find a answer in a few days.




I dont have the hardware so I cannot help you there. Do you know how to recover it if you get the firmware ? do you know the JTAG pins for programming ?




darkspr1te

lern01:

--- Quote from: darkspr1te on December 27, 2023, 06:17:27 am ---It's quite possible that no one has it or has access to it. Other reason could be that some users dont daily this site and you may find a answer in a few days.




I dont have the hardware so I cannot help you there. Do you know how to recover it if you get the firmware ? do you know the JTAG pins for programming ?




darkspr1te

--- End quote ---

I know, I have a TL866 programmer. I've done other models before.
eb4fbz:
TDS1000C and TDS2000C all share the same firmware. You can even find the binary inside the Tek official upgrade. https://www.tek.com/en/support/software/firmware/firmware-update-tds1000c-sc-and-tds2000c
lern01:

--- Quote from: eb4fbz on December 27, 2023, 12:01:05 pm ---TDS1000C and TDS2000C all share the same firmware. You can even find the binary inside the Tek official upgrade. https://www.tek.com/en/support/software/firmware/firmware-update-tds1000c-sc-and-tds2000c

--- End quote ---

I need .bin or .hex file. Because the firmware in my EPROM is damaged, the oscilloscope cannot be turned on.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod