Products > Test Equipment

Who can provide TDS2024C EPROM firmware backup?

(1/4) > >>

lern01:
The EPROM firmware of one of my TDS2024C oscilloscopes is damaged. I hope that friends from the almighty EEVblog can provide me with a copy.Or the firmware of TDS2004C and 2014C will also work. Thank you very much!
Email:lern01@outlook.com

darkspr1te:
It's quite possible that no one has it or has access to it. Other reason could be that some users dont daily this site and you may find a answer in a few days.




I dont have the hardware so I cannot help you there. Do you know how to recover it if you get the firmware ? do you know the JTAG pins for programming ?




darkspr1te

lern01:

--- Quote from: darkspr1te on December 27, 2023, 06:17:27 am ---It's quite possible that no one has it or has access to it. Other reason could be that some users dont daily this site and you may find a answer in a few days.




I dont have the hardware so I cannot help you there. Do you know how to recover it if you get the firmware ? do you know the JTAG pins for programming ?




darkspr1te

--- End quote ---

I know, I have a TL866 programmer. I've done other models before.

eb4fbz:
TDS1000C and TDS2000C all share the same firmware. You can even find the binary inside the Tek official upgrade. https://www.tek.com/en/support/software/firmware/firmware-update-tds1000c-sc-and-tds2000c

lern01:

--- Quote from: eb4fbz on December 27, 2023, 12:01:05 pm ---TDS1000C and TDS2000C all share the same firmware. You can even find the binary inside the Tek official upgrade. https://www.tek.com/en/support/software/firmware/firmware-update-tds1000c-sc-and-tds2000c

--- End quote ---

I need .bin or .hex file. Because the firmware in my EPROM is damaged, the oscilloscope cannot be turned on.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod