Products > Test Equipment

Why some brands don't do LCR meters?

<< < (8/11) > >>

alm:
In addition to the NanoVNA, also read up on the LiteVNA. I believe it's a bit higher performance and more stable (based on what joeqsmith wrote in the past), but also a bit more expensive than the NanoVNA.

MathWizard:
Yeah I have to get one, I don't need a Siglent SSA3021X+ yet, but I'm watching those too. Later this month I should get a Nano/version, from the legit sellers, not a clone.

For sub 50MHz stuff, and I stick to ebay/amazon level prices, about how much money would all the accessories cost for a Nano, and to hook up to the DUT , and make little test jig's or whatever ? Sometimes I see splitters used so your scope can be hooked up too. I know this stuff can add up real quickly.

Kosmic:
The little board on the picture I posted is normally 5$US (with all connectors and stand).

pope:
I just pulled the trigger on a ET4510.

We shall see... 

pdenisowski:

--- Quote from: Kosmic on December 03, 2023, 12:05:16 am ---LCR meters rarely exceed 1Mhz. Normally with higher frequencies, people switch to a VNA.

--- End quote ---

The R&S LCX goes up to 10 MHz

https://www.rohde-schwarz.com/us/products/test-and-measurement/lcr-meters-and-impedance-analyzers/rs-lcx-lcr-meter_63493-1172288.html

The "LCR Meter vs VNA" question comes up often enough that we created a web page to help people decide (since we make both types of instruments)

https://www.rohde-schwarz.com/uk/products/test-and-measurement/essentials-test-equipment/dc-power-supplies/lcr-meter-vs-vna_256867.html

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod