Products > Test Equipment
Sencore LC102 & LC103 Capacitor & Inductor Analyzer
<< < (5/20) > >>
coromonadalix:
Uploaded the LC102 calibration procedures at K04BB too
philexile:
Hello,

I recently purchased an Sencore LC103 and I'm waiting for it to be delivered. It will be arriving without a power supply and I'm having problems identifying the 3-prong power jack on the rear of the unit. Does anyone know the name of this connector? I don't think that it is proprietary to Sencore, but I could be wrong.

Should I instead ignore that and go through the 12v battery connector? If so, what sort of molex connector is that?

Also, I've attached the calibration procedure PDF for the LC103. It appears to require specific software and hardware. You'll see mention of Final Cal Test program, final test box, ringer test box, ringer cal box, final test box, large inductance box, and high cap box. There is also mention of a Standards book "on the bench."

Does anyone have access to the items noted above or performed a calibration?

Thank you
HighVoltage:
I just took my LC103 apart for the first time but it is difficult to get to the connector on the inside.
It would require to remove the top or bottom PCB

Here are some tear down pictures.

I do not know the manufacturer of that 3 pic connector

HighVoltage:
More pictures
mr.fabe:

--- Quote from: HighVoltage on August 18, 2019, 01:32:07 pm ---I do not know the manufacturer of that 3 pic connector

--- End quote ---

I don't know the manufacturer but the connector type is a Mini-IEC (ACL117) that sells for $7.95 AUS.

https://www.wagneronline.com.au/mini-iec-to-bare-wire/ac-power-leads-iec/power-240vac/power-lighting/acl117-47410/969715/pd/

You should probably ask the sysop move this topic to test equipment or start a fresh thread....
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod