Products > Test Equipment

Sencore LC102 & LC103 Capacitor & Inductor Analyzer

(1/20) > >>

HighVoltage:
This thread is about the Sencore LC102 and LC103 Capacitor & Inductor Analyzer





Attached are the LC102 and LC103 datasheets

cahillsr:
I have one needs repair. Everything seems to  work execpt ESR and leads won't zero on open. I am in NH USA

HighVoltage:
I have found a broken Sencore LC103 instead and bought it.
Might be a good repair thread.

coromonadalix:
Just bought one too, for a very low price, (never tough it would be best offer accepted loll)  clean casing, nothing broke,  no xformer no test probes. 
Luckily i have a matcing xformer with the right plug who will fit nicely, and at my company we have very good Belden rf cables who could work.

The zeroing problems are known,  you have a white relay who oxidize over time, some had sucess with deoxit spray,  but opening the relay is tricky, and you have to be careful not to contaminate the inside with debris.

You have the test plug with the integrated fuse who get loose some times

And some had problems with the small black reed relays, they get stuck or dont operate properly

And in the manual you have a section for the specs or failures when zeroing,  impedances values  etc..  and use an 93-96 ohm low capacitance cable ...


LINK :  Sencore LC-102 Cable 'zeroing' issue and 'fix'
https://www.antiqueradios.com/forums/viewtopic.php?f=8&t=286666

Some link here :
https://www.eevblog.com/forum/testgear/sencore-lc102-cap-analyzer/
Replies #20 and 21  are interesting

HighVoltage:
Nice, thanks for the info
I am looking forward to get my ReZolver !

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod