Products > Test Equipment
Yokogawa Bench Meters, Slim Pickings.
<< < (11/11)
2N3055:
My 7562 has LT1021 as reference.
Looking at the board at the time, there are unpopulated pads for a LM399 and a opamp, I guess also for a 10V circuit..
man216:
Hello guys! I just purchased this Yokogawa 7552 Bench Multimeter for myself. Can you tell me if it has an audio continuity feature? Thank you.
maxwell3e10:
I setup a continuity check using the limit checking pass/fail output. Put a buzzer in the back and program hi/low limits for resistance. It helps to have the memory card, so one does not need to reprogram the limits every time the meter is turned on.
scopeman:
A couple pf years ago I bought on close out a Iwastu VOAC 7062 which is Identical to the Yokogawa DM7560 6 1/2 digit DMM. As Yokogawa built these for Iwatsu the quality is excellent. There is a teardown of these units on the forum.

As you may know one of the divisions of HP was YHP Yokogawa HP. The VOAC 7062/DM7560 have voltage reference chips (heated buried Zener like LM395 IIRC) that are marked with an HP part number.

This is no surprise as I believe YHP builds or built some DMM products for HP and perhaps continues to do so. The DM7560 is very similar to the current 6 1/2 digit DMM's of late from HP/Agilent/Keysight.

YHP was most famous for their LCR Meters and Bridges and I believe the HP9342? Q meter and the HP4329 HiZ meter among other products. Top quality all the way.

Enjoy your new meter!

Sam
W3OHM
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod