Products > Test Equipment
You can't unlock a MSO1000Z series scope without a memory dump and other lessons
<< < (2/2)
Howardlong:

--- Quote from: Luddi on October 07, 2015, 10:56:53 pm ---https://www.eevblog.com/forum/testgear/rigol-mso2000-series-hacking/msg745473/#msg745473

don't know if it works with the 1000z too.

--- End quote ---

Does not work on an MSO1000Z I'm afraid.
serendipity:

--- Quote from: pickle9000 on October 07, 2015, 02:21:39 am ---I have watched a fair number of your vids. You do an excellent job.

--- End quote ---

I didn't do those videos. I am just quoting someone else' work.


--- Quote from: Orange on October 07, 2015, 08:41:30 am ---
--- Quote from: pascal_sweden on October 07, 2015, 08:30:56 am ---Can't you do a memory dump without opening the scope?
There is an undocumented SCPI/LXI command to perform a memory dump through network interface.

No need to open up your scope, mess around and void your warranty.
Why make things more difficult than they are?

--- End quote ---
What is this 'undocumented command' then look like ??

--- End quote ---

I think you are referring to the :SYST:UTIL:READ? command. I tried it on my MSO1074Z running firmware 4.00 and 4.03. The command didn't work with either firmware.
Howardlong:
There is a thread specifically on the MSO1074Z hacking here https://www.eevblog.com/forum/testgear/is-the-rigol-mso1074z-hackable/ which has links to the specific posts.

It seems as though the serial numbers have since been modified slightly.

My core dump took about 15 minutes, there's an adapter_khz setting for some JTAG adapters.

I agree that a wiki would be good... I think more than enough people have gone through the pages to justify that, are you offering? :-)

Sandra's post here in particular is probably a good one too https://www.eevblog.com/forum/testgear/sniffing-the-rigol's-internal-i2c-bus/msg569236/#msg569236
NutuElectronist:
Hi all. I have RIGOL1074Z with red screen dead and i try all methods but no success . I try update with last update downloading from RIGOL site but no success . When plug USB stick with update file in front socket and after power up press HELP button i thing go to update because CH1 blinking and led from my usb stick but after few seconds all leds from front panel blinking .
Please can help me with solutions to give another life for my RIGOL ?
Thank you.
 
wasedadoc:

--- Quote from: NutuElectronist on January 26, 2024, 09:52:17 am ---Hi all. I have RIGOL1074Z with red screen dead and i try all methods but no success . I try update with last update downloading from RIGOL site but no success . When plug USB stick with update file in front socket and after power up press HELP button i thing go to update because CH1 blinking and led from my usb stick but after few seconds all leds from front panel blinking .
Please can help me with solutions to give another life for my RIGOL ?
Thank you.

--- End quote ---
1.  Your post is not related to this topic.

2.  You already asked the same question less than 24 hours ago at https://www.eevblog.com/forum/testgear/rigol-red-screen-of-death/msg5296009/#msg5296009.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod