| Products > Test Equipment |
| Your Experience on LCR Meter DER EE DE-5000 / Hantek 1833C |
| << < (3/7) > >> |
| Marko56:
AliExpress has UNI-T Kelvin Clip sets with clip and tweezer models. I paid ~$45 CDN for the clip version ( UTR-L100K-H) IIRC the tweezers were $65CDN. |
| coromonadalix:
--- Quote from: philwong5176 on May 31, 2022, 05:15:52 pm ---I recently received my Hantek 1833c. I need a Kelvin Clip but found nothing in their website. Does anybody know which Kelvin Clip models works with this meter? Also: I am aware I could plug this meter into a PC, but what software could I use to interface with the meter? Yes I emailed the company, heard NOTHING back. :( --- End quote --- They have an +/- 200 mb software download ?? http://www.hantek.com/products/detail/16180 oh their download speed is sloooooooooooooooooooooow pff loll |
| NoMoreMagicSmoke:
Can anyone who has the Hantek measure a resistor at the 100KHz frequency? I have an ET342 that measures significantly low, and since the Hantek appears to share a very similar design, I am curious if it has this same issue. |
| bdunham7:
--- Quote from: TimFox on May 11, 2022, 11:11:48 pm ---I would prefer that it show negative capacitance, since I can easily deal with that. In that case, I would prefer a display in terms of resistance/reactance or admittance/susceptance, like some expensive bench meters have. --- End quote --- Does it not have the option of simply displaying Z and Ø ? This is where I go with my LCR meter when results are unstable or unexpected. If the readings don't make sense and Z is very high or very low you then know to try a different frequency, level or mode. |
| hexreader:
1 Megohm resistor shows as about 500k at 100kHz serial mode "X" shows as about 450k - maybe you need to add the two together? - wild guess - I have no understanding Parallel mode shows about 900k Ohms with 100kHz 100Hz gives probably correct value of 980k Ohms in any mode Hantek 1833C |
| Navigation |
| Message Index |
| Next page |
| Previous page |