Products > Test Equipment

Your Experience on LCR Meter DER EE DE-5000 / Hantek 1833C

<< < (3/7) > >>

Marko56:
AliExpress has UNI-T Kelvin Clip sets with clip and tweezer models. I paid ~$45 CDN for the clip version ( UTR-L100K-H) IIRC the tweezers were $65CDN.

coromonadalix:

--- Quote from: philwong5176 on May 31, 2022, 05:15:52 pm ---I recently received my Hantek 1833c. I need a Kelvin Clip but found nothing in their website.

Does anybody know which Kelvin Clip models works with this meter?

Also:
I am aware I could plug this meter into a PC, but what software could I use to interface with the meter?

Yes I emailed the company, heard NOTHING back.  :(

--- End quote ---

They have an +/- 200 mb software download ??

http://www.hantek.com/products/detail/16180

oh  their download speed  is sloooooooooooooooooooooow    pff  loll

NoMoreMagicSmoke:
Can anyone who has the Hantek measure a resistor at the 100KHz frequency? I have an ET342 that measures significantly low, and since the Hantek appears to share a very similar design, I am curious if it has this same issue.

bdunham7:

--- Quote from: TimFox on May 11, 2022, 11:11:48 pm ---I would prefer that it show negative capacitance, since I can easily deal with that.  In that case, I would prefer a display in terms of resistance/reactance or admittance/susceptance, like some expensive bench meters have.

--- End quote ---

Does it not have the option of simply displaying Z and Ø ?  This is where I go with my LCR meter when results are unstable or unexpected.  If the readings don't make sense and Z is very high or very low you then know to try a different frequency, level or mode.

hexreader:
1 Megohm resistor shows as about 500k at 100kHz serial mode

"X" shows as about 450k - maybe you need to add the two together? - wild guess - I have no understanding

Parallel mode shows about 900k Ohms with 100kHz

100Hz gives probably correct value of 980k Ohms in any mode

Hantek 1833C



Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod