Products > Test Equipment

ZEEWEII DSO1511G not showing square at 2mhz when other people's do.

(1/5) > >>

slikvik:

Calibrated my probe as per the manual and following along exactly to the calibration in Adrian's Digital Basement video.


* It looks fine a 1Khz (see attachment)
* Switching to 2Mhz looks like the second attachment.
* Adrian's Digital Basement did exactly the same and got a much better square when viewing 2Mhz from the signal generator. (3rd attachment)

The review on this forum also showed a pretty good 2mhz square: https://www.eevblog.com/forum/testgear/dso1511e-review/

Do I have a dud version of the device?


tunk:
What's your signal generator? - it could be caused by it.

Aldo22:

--- Quote from: slikvik on May 08, 2024, 03:15:13 pm ---
* Switching to 2Mhz looks like the second attachment.
--- End quote ---

If you are using the internal signal generator, I can't see how that is connected.

wasedadoc:

--- Quote from: tunk on May 08, 2024, 04:50:44 pm ---What's you signal generator? - it could be caused by it.

--- End quote ---
The generator is probably the one in the scope but OP should confirm that.

csuhi17:
Use it's own signal generator, it knows up to 2Mhz.
Why and what is the ground of your signal generator connected to??

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod