Products > Thermal Imaging
Control software for Raytheon cores?
Logan:
Hi friends.
Anyone have control software (GUI or command list) for Raytheon BST and ASi cores?
Also, does the analog BST (300A) cameras support serial communication?
Thanks!
Bill W:
BST core control software was found and posted on the forum.
I have put a copy on my website
http://www.fire-tics.co.uk/project3/index.htm
ASI 'customer' did very little, just a start screen I think. I do not think the ASi 'factory' ever got out.
Bill
Logan:
Thanks Bill.
But I think your link is for digital (300D) BST only, what about analog versions?
Also I've seen some feature-rich controller for ASi screen shots here: https://www.eevblog.com/forum/thermal-imaging/raytheon-l-3-thermal-eye-x-series-repair-new-patient-for-fraser-x50/
Is that considered as "controlled release" or something?
Bill W:
I am not aware of anything for the 'analog' BST cores. I do not recall any control being advertised on the main 80-way but would need to check further - and cannot at present.
I think calibration access was via the PCB finger edge connector.
The GUI you have found is for later ASi series, 3500/3600/4500. My comment referred to the earlier 2000AS core
Bill
Logan:
Hi Bill.
Just another question... Can we increase the gain on analog BST cores? I remember read in the forum that there's a "pot" to adjust, how can I do it?
Thanks.
Navigation
[0] Message Index
[#] Next page
Go to full version