Products > Thermal Imaging

FLIR E4 Wifi Resolution and Menu Hack Thread

<< < (255/258) > >>

Bud:
These puppies are hard to kill. You likely doing something incorrectly. Do you have Flir device drivers installed? To eliminate some variables, get a machine or virtual machine with WinXP, intstall Flir device drivers and Flir Tools. That should give you USB access. Then you can run the recovery procedure.

saqibshafiqss:
Did the basic & advanced hack, resolutions and menu on my flir E6 2.0 Wi-Fi 3.9.0 using windows 11 on a newer laptop and works perfectly fine, took a whole day as im a complete beginner and there was some issues but figured it out eventually. Thanks to everyone responsible and the rest of this community for this hack.

Tolek:

--- Quote from: tcq1000 on January 12, 2023, 05:56:51 am ---There is a problem. The equipment is FLIR E4 2.0L 3.16. The three points for temperature measurement after HACK are SP1、SP2、SP3 instead of Hot、 Cold ， What is the problem?

Resolution and palette HACK are completed normally

--- End quote ---
I have the same issue... Do you have solution?

someguy2023:
Got it all fixed up. Plugged it into a WinXP laptop after getting all the software installed and got back into it. Thanks Everyone!

Bud:

--- Quote from: Tolek on January 30, 2023, 09:04:33 pm ---
--- Quote from: tcq1000 on January 12, 2023, 05:56:51 am ---There is a problem. The equipment is FLIR E4 2.0L 3.16. The three points for temperature measurement after HACK are SP1、SP2、SP3 instead of Hot、 Cold ， What is the problem?

Resolution and palette HACK are completed normally

--- End quote ---
I have the same issue... Do you have solution?

--- End quote ---
Just replace the 3 point preset with the original one from your backup. ( You backed up your camera before the change, didn't you?)

Navigation

[0] Message Index

[#] Next page

[*] Previous page