EEVblog Electronics Community Forum
Products => Thermal Imaging => Topic started by: asantos1966 on May 16, 2024, 01:57:49 am
-
Dear all,
I broke off a Flir One Pro battery connector while replacing the old battery for a new one. Fortunately, I found enough information on the forum below to be able to purchase a new
PICO-EZMATE PLUS1.0 PLUGASSY ETP to replace the broken connector.
Before doing anything else, I would like to ask if anyone would be aware of the best way to proceed to replace the connector. For instance, should I only completely remove the broken connector and use electrically conductive glue (such as Atom AA-DUCT 902 Silver Epoxy Adhesive) to attach/glue the new one? Or would something else be better?
Many thanks!
https://www.eevblog.com/forum/thermal-imaging/flir-one-g2-battery-for-replacement/ (https://www.eevblog.com/forum/thermal-imaging/flir-one-g2-battery-for-replacement/)