Products > Thermal Imaging

FLIR One Pro battery connector

(1/1)

asantos1966:
Dear all,

I broke off a Flir One Pro battery connector while replacing the old battery for a new one. Fortunately, I found enough information on the forum below to be able to purchase a new    
PICO-EZMATE PLUS1.0 PLUGASSY ETP to replace the broken connector.

Before doing anything else, I would like to ask if anyone would be aware of the best way to proceed to replace the connector. For instance, should I only completely remove the broken connector and use electrically conductive glue (such as Atom AA-DUCT 902 Silver Epoxy Adhesive) to attach/glue the new one? Or would something else be better?

Many thanks!

https://www.eevblog.com/forum/thermal-imaging/flir-one-g2-battery-for-replacement/   

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod