Products > Thermal Imaging
Flir1 G2 lens experiments
Bill W:
A 'frankenstein' camera is alive ! This took a F1G2 module and the idea is to be able to fit various alternative lenses that I have to the F1G2.
The lens plate is a prototype routed PCB that carries a connector for the USB from the F1G2, took a couple of goes to get the right hole spacings and pillar heights. Ground has had to be done by soldered wire - the F1G2 USB connector is only 4 pins and no ground, ground is via a spring finger of all stupidity :--
Anyway it is now quite solid and the phone can be remoted down the USB cable.
Still to look at a better battery setup, really down to how well I can connect instead of the awful connector that FLIR used but this serves for now,
Also the camera tripod mount is upside down :palm:
Bill
Bill W:
View with original FLIR lens, but focussed correctly.
These are about 44 degrees horizontally, based on fl of 1.2mm
Bill W:
Now a 4.3mm Ge / ZnS lens at f/1.1
These are about 20 degrees horizontally
Bill W:
Now the 6.3mm f/1, all Ge
These are about 14 degrees horizontally
Bill W:
Finally for now the 8.6mm f/1 all Ge triplet
These are about 10 degrees horizontally
Navigation
[0] Message Index
[#] Next page
Go to full version