Products > Thermal Imaging

Fluke Camera Hacking

<< < (4/4)

f14:
Hi
I have Fluke Ti27 with problem like this picture below. no thermal detect and temp raise up slowly to 42 43oC
seem the thermal sensor is dead?. because it use DRS U3510 sensor and hard to find :(
thank you!

Fraser:
Do you hear the FFC flag activating soon after boot ? It could be the FFC flag stuck and blocking the optical path. >40C is higher than I would have expected for the FFC flags surface but still worth checking.

Fraser

f14:
Hi
it working perfectly. I hear it serveral time when the camera working
thanks

f14:
Hi
I have open this camera and check/clean. not thing strange inside . now the problem is the temp range very small 70-100oC scale( auto or manual range are same issue) and not accurate (300oC it show 100oC. and room temp ~30oC it show 70oC )
have any idea? I have clean the blue tap connector between sensor and the pcb

radioorizont:
Hi Chanc3,
Could you please advise how you connected to the cam,era's IP?
I also see a network device with:
Interface: 10.0.5.193 --- 0x2a
  Internet Address      Physical Address      Type
  10.0.5.194            00-c0-17-05-c2-00     dynamic
  10.0.5.195            ff-ff-ff-ff-ff-ff     static
The problem is i can't connect in a browser window.
Did you use Total Commander , was there a password required to access the folders like in Flir thermal cameras?

Thanks,
Dan.

Navigation

[0] Message Index

[*] Previous page