EEVblog Electronics Community Forum

Products => Thermal Imaging => Topic started by: seek_cp on October 10, 2020, 02:37:30 pm

Title: how to modifiy the seek compact pro need help
Post by: seek_cp on October 10, 2020, 02:37:30 pm

hello guys need help

i all ready bought a znse lens FL 50.8 but notings happen its the same

the capture is blurry anyone can help me how
 to make clear the capture

Title: Re: how to modifiy the seek compact pro need help
Post by: Fraser on October 10, 2020, 09:53:36 pm

The ZnSe lens sits in front of the Seeks Standard lens (not instead of it!) and you set the manual focus near infinity. Move towards the target until the image is either in focus or close to focus. Adjust manual focus on Seek until good focus is achieved.

Note that a 50.8mm Focus point lens will not provide perfect focus at 50.8mm when used as a supplementary lens but it will be close to that distance.

Fraser