Products > Thermal Imaging

Infiray C210 Thermal Camera review

<< < (5/7) > >>

BrotherEstapol:
Do you mean this item?
https://www.aliexpress.com/item/1005002656448420.html

I'm not sure if that sort of design could work with the c210, but I'll figure something out! There's always a fix! ;)


--- Quote from: tigerbengal2009 on September 08, 2021, 07:05:15 am ---Does the c210 allows you to see a short on let's say laptop motherboard ? 25 hz and the resolution is enough to see a short creating heat in real time?

--- End quote ---
I am not sure, I haven't had a chance to look at any circuit boards with this yet unfortunately! I think if you're buying it to check for shorts, you probably would want a macro lens.

jairbj:
Hi @littleboot, thank you for the review.

I bought one and it has arrived 3 days ago. It's my first thermal camera.

To my surprise, it is a heavy bulky device. I wasn't expecting it.  :-DD

Until now the only thing I miss is the ability for recording videos direct on camera.

Also, I bought the macro lens (it hasn't arrived yet).

Attached a picture for size comparison between a Fluke 62Max Infrared Thermometer and the Infiray C210

jairbj:
My macro lens has arrived.

Lens: https://www.aliexpress.com/item/32241074105.html
Diameter: 20mm
Focal Length: 50.8mm

I attached some images.

Also posted the build of my lens holder here:
https://www.thingiverse.com/make:968854

jazzyjayzee:
Hello! Also just recently got the C210 and it is pretty impressive. Had an odd startup that only indicated 0 degrees, though the thermal image was intact. Only happened once.

Question - seller provided the PC analysis software but is there a trick to configuring this to run on Win 10? I tried a couple times on different machines, seems to install some run-time bits, installer seems to behave, but running the program gives me an instant alert in Chinese that Google translate tells me is "not supported" and will not proceed.

Thank you in advance! great thread!

littleboot:

--- Quote from: jairbj on September 20, 2021, 01:45:57 am ---My macro lens has arrived.

Lens: https://www.aliexpress.com/item/32241074105.html
Diameter: 20mm
Focal Length: 50.8mm

I attached some images.

Also posted the build of my lens holder here:
https://www.thingiverse.com/make:968854

--- End quote ---
Thank you for creating the lens holder!, I will 3D print one for myself. Very nice design using the rubber bands :-+

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version