Got myself faulty iOS Flir One Pro, it does charges, turns on (green light blipping) but when i plug it in to the iPhone doesn't detects.
1st assumption was that lightning port assembly is damaged and i decide to play around.
Pulled port assembly from my Micro USB Android version of the Flir One Pro and used that.
Looks like device falls in to the "init-loop" green light still blinks but image starts to load for 2sec and then disconnects.
Measured voltage on D+ line and it holds 3.x V for 2-3seconds and jumps to a 0 for 2-3 seconds and loops. D- shows ~100mv.
Filter and fuses on D+ / D- are good. So i still think issue is in the lightning port assembly.
I read on eevblog that Flir 1g2 have setting in to the firmware for the port (L/U). I also found Serial port pinout for 1g2 and looks 1g3 has same header.
Haven't tried to connect to Serial yet but will try later today to see output.
Decide to ask upfront, how would i update firmware to handle Android. And may be i am missing something valuable.
Thank you.