Products > Thermal Imaging

OpenIRV. ISC0901B0 (Autoliv NV3, FLIR E4/5/6/8) based opensource thermal camera

<< < (67/67)

Citizen:

--- Quote from: MIKUTA on May 27, 2022, 02:10:05 pm --- I don't have the technical knowledge to understand exactly what is going on, but I heard that the camera can be activated by following the URL below.
https://github.com/pavelmalik/BMWCanBridge
https://www.bmwcustomretrofit.com/navigation-retrofits/BMW-Night-Vision-System-Activator

--- End quote ---
I know similar projects, but they use the original video processing unit from the car. The activator is already working with this block.

LesioQ:
I tried to find this info in the OpenIRV docs, but couldn't : what kind of LCD display should be used for this project ?
I mean the model / type that needs no further firmware modifications.

rockwell:
Should one need a new camera, I have one to let. contact by PM.

VGN:
Hello!

Have added datasheets for LCD and focus motor: https://github.com/OVGN/OpenIRV/tree/master/docs/BOM/BOM_v1.1.0
You can easily find both. Note that there are a lot of manufacturers that make same 6mm geared DC motors.
Use provided motor datasheet as a reference. The key parameters are diameter (6mm), gear ration (~1:26), shaft geometry and voltage (nominal 3.0V).

LesioQ:
Thank You. That clarifies things further. And how is Your progress with bootloader part ?
I guess FPGA needs to be programmed ISP, so will bootloader be involved ?

Navigation

[0] Message Index

[*] Previous page