EEVblog Electronics Community Forum

Products => Thermal Imaging => Topic started by: masterprince on July 10, 2020, 01:41:11 am

Title: Req: Fir One Pro 3D Image
Post by: masterprince on July 10, 2020, 01:41:11 am

Hi All,
Hope all is well with you

I am in need of the attached 3D model for my Flir One Pro or anything which can fit lens in. Appreciate if any one has it please upload it

Thanks
Hassan

Title: Re: Req: Fir One Pro 3D Image
Post by: rek on August 19, 2020, 02:41:03 pm

I have Fusion 360 models of FLIR One tripod adapters I've designed, it should be trivial to add a 20mm lens mount to the front of them. I have one of those 20mm ZnSe lenses on order to work with, however I no longer have any FLIR Ones (sold them to fund an E4)

I need to check my design history but I definitely have a holder for the Gen3 and pretty sure I have one for the Gen2 as well.

This is how I had an F1G3 set up to take measurements over time. (There are holes in the bottom of the mount to access the power button and supply external power to the FLIR pod)