Products > Thermal Imaging

Seek reveal Pro review & teardown

(1/2) > >>

mikeselectricstuff:

amyk:
I found it a bit funny that the high-FPS version's framerate is mentioned as ">15Hz" in their datasheet, and indeed 16 > 15. It still looks rather slow for good video though, and I wonder why, if they were going to be export-restricted anyway, they didn't go for the full 30Hz --- maybe due to processing to remove noise? It'd be interesting to see what raw signal the sensor outputs.

mikeselectricstuff:
Output rate from sensor appears to be 16Hz. The lag suggests they may be doing a moving avarage of a few frames

encryptededdy:
As mentioned in the video comments, it looks like the frame rate increases significantly when you switch from full frame to normal mode.

Fraser:
Another interesting video Mike  :-+

Fraser

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod