Products > Thermal Imaging

Vevor SC240N / TopDon TC004 / InfiRay C200 / Hisilicon HI3516DV300

<< < (11/15) > >>

Honusnap:
Ok seen the J16, do you have the specs of the connector ?





EDIT : Ok i think i found it : JST SH1.0 6pin



Found a PL2303 : But have a question, i've read some pages on the subject and seems there are ... REAL RS232 levels (like 12V/5V), RS232 levels (like 5/3.3V).. i'm kind lost here, the PL2303 seems to be ok to connect to the C200 right ? It got RS232 levels at 3.3V or 5.5V, which voltage is the good one for the C200 board ?



Or maybe this one which is able to do far more : CP2102

jetpad:
My solution was to solder one of these

    https://www.amazon.com/gp/product/B07PDQKHJ2/

to a little scrap connector I had. Then connecting that to

    https://www.amazon.com/gp/product/B0BG2BPVXV/

That connects to

    https://www.amazon.com/gp/product/B074VN9ZG4/

Which plugs into my MacBook. Just a temporary setup while it is disassembled.

Honusnap:
Hello Jet,

Good, SH1.0 connector confirmed  ^-^, i would like to avoid the DB9 connector cause i haven't got any  :), i bought the PL2303 and the CP2102 (which will help in my RS485 projects anyway), and a bunch of SH1.0 connectors .. should be ok...

jetpad:
Ok, I was able to get the firmware loaded back on the SC240N thanks to Manawyrm. Lots of things tripped me up since this was a little out of my norm. The two main ones were: 1) The RX connection on the serial cable wasn't working so I thought the camera was ignoring me and 2) I wasn't pressing the spacebar fast enough to interrupt U-boot.

Now, after I put it all back together, I realized it wasn't displaying the correct hi, low and center temperatures correctly. It's displaying -273.1 C for all three. The thermal image looks right, it's just that the temperatures never change.

Do I need to do some sort of calibration? Has anyone else encounter this?

Honusnap:
Hello,

I think i've read something about calibration being specific to each device (obviously), isn't there a menu to calibrate ..? I searched but did not find infomation while i think i've seen something about this...
About the reviving of your device, what did you flashed ..? The whole firmware through the firmware script, or just some files ?
Cause nobody seems to have the firmware i have on my device .. (chinese one) and so i got no source, appart from what seems to be a partial firmware (4 or 5 files).

Navigation

[0] Message Index

[#] Next page

[*] Previous page