Products > Thermal Imaging

Vevor SC240N / TopDon TC004 / InfiRay C200 / Hisilicon HI3516DV300

<< < (12/14) > >>

I can see that there is a solder free way to copy files to the Infiray C210, do anybody know if this works for this series as well ?
I have the Vevor SC240M aka C200 Pro (video recording and normal cam as well) - And if so, does somebody have an original or whatever I am going to replace ?

Hello Jet,
Did you suceed calibrating your device ?
I'm in contact with Infiray and for my device the guy said i ned to send it back for flashing firmware again .. AND recalibrate the device, they also added that they need something called a dark mater to calibrate, it's something the temperature is well known.
But i suppose we can calibrate it with something else if we do not need extreme precision afterall.

About your SC240N, how did you flash the firmware ? What tools and procedure did you follow ?

I need to flash my C200 Pro (aka SC240M), if someone got a SC240M OR a C200 Pro firmware .. i would love to have it.

Thanks .. :D

No it's still not back to the original state because I guess it needs to be recalibrated and I don't know if that is possible without sending it back. You've probably gotten farther along on that aspect since I haven't contacted Vevor about it yet. But it does display a thermal image, just without all the nice temperatures on it (and probably not in a calibrated way). Sorry, I don't have a copy of the SC240M firmware, just the SC240N. I don't remember the exact commands I used to get the firmware back on but it was something like this. Please verify each one before using them as I'm sure they need to be each customized for your setup. These were run on my MacBook after getting the serial cable working between the SC240N and the MacBook.

cd sbin
fdisk -l /dev/mmcblk0

diskutil list

diskutil unmountDisk /dev/disk4

sudo dd if=/Users/jetpad/Downloads/vevor-sc240n-firmware/vevor-sc240n-emmc.img of=/dev/rdisk4 bs=1m

; This command took about 10 minutes for me.
sudo dd if=path_to_image.img of=/dev/rdiskX bs=1m

diskutil eject /dev/disk4


dd if=/dev/mmcblk1 of=/dev/mmcblk0 bs=4M

I checked both Topdon TC004 and TC005 firmware, they are identical BUT 2 files :


S90start seems different at first but is in fact differently organised.

Those 2 firmwares got different numbers :
TC004 : V1.4.7.8(109)
TC005 :  V1.4.7.8(105)

I also got a C200 PRo V1.3.8(131), S90start is the same as TC004 and TC005, iray-hisi-camera-new and iraytek_softer_01_new are also present and diferent then the TC004 or TC005.

Nobody got a Vevor firmware ?

I picked up one of these and am pretty happy with it so far, haven't opened it up yet though. I wanted to do it all at once when I put together the macro lens.

If anybody has used one of those 18mm CO2 laser lenses with it (such as the 3D print tsys posted on the first page) what focal length did you use? I'm not  sure if it's as simple as 'use a 5cm FL to get a 5cm minimum focal length' since I have no idea what optics are inside the camera otherwise. And the lenses are $25 each or so, so I'd prefer not to guess several times.


[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod