(RU)
Привет!
Что бы открыть камеру нужно аккуратно, не спеша начиная, с ула , скальпелем оклеить чёрный скотч,
на передней панели. Это самоклейка. Под ней вы обнаружите 4 винта. Открутите их. Далее всё просто...
Видите крепёжные винты - можете смело их откручивать.
ВНИМАНЕ!!! я не делал попыток переключить разрешающую способность при помощи недостающего резистора.
Это только ПРЕДПОЛОЖЕНИЕ . Если Вы рискнете - сообщите о результатах.
Я подключал к USB 2.0 моем PC и запустил тест с
https://ru.webcamtests.com/и получил картинку . Так Выглядит необработанная Андроидом картинка исправного тепловизора в тестовом режиме.
И представляет собой 2 одинаковых по размеру кадра: 1- черно-белый, 2 зелёный.
Так выглядит свет лампы накаливания от абажура на белом потолке моей комнаты.
(EN)
Hello!
To open the camera, you need to carefully, slowly starting, from the street, paste over black tape with a scalpel,
on the front panel. This is a sticker. Under it you will find 4 screws. Unscrew them. What follows is simple...
You see the fixing screws - you can safely unscrew them.
ATTENTION!!! I made no attempt to switch the resolution with the missing resistor.
This is just a SUGGESTATION. If you dare - report the results.
I connected to USB 2.0 on my PC and ran the test from
https://ru.webcamtests.com/and got a picture. This is how a picture of a working thermal imager in test mode, raw by Android, looks like.
And it represents 2 frames of the same size: 1 is black and white, 2 is green.
This is how the light of an incandescent lamp looks like from a lampshade on the white ceiling of my room.
Thank you!
DuRak (species: common fool, family: sluggishly curious)
Modify message