Author Topic: ESP32 Based IoT Project - Schematic & Board Layout  (Read 4091 times)

0 Members and 1 Guest are viewing this topic.

Offline drphil3d

  • Newbie
  • Posts: 2
  • Country: us
ESP32 Based IoT Project - Schematic & Board Layout
« on: September 30, 2020, 04:42:16 am »
I have a nearly complete schematic and rough idea of the board layout in Fusion 360 / Eagle. However am not an electrical engineer and lack the ability to finish this on my own. I'm looking for somebody that can pick up where I left off or work with me to complete the project. I've done a lot of the hard work of creating libraries and and component sourcing.

What it consists of:
- power supervisor
- voltage regulators
TFT Display with resistive touchscreen
some buttons and rgb leds
Li-ion charge controller
Load Cell Amplifier

I'm looking to hire on contract or hourly basis. There's likely around 20 to 30 hours of work required.
Let me know if you are interested, Thanks! ;D

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo