EEVblog® Electronics Community Forum

General => Work Wanted => Topic started by: Bosteve on April 03, 2025, 08:01:53 pm

Title: Calibration wanted for Tektronix 2465B
Post by: Bosteve on April 03, 2025, 08:01:53 pm

Maybe a long shot, but hoping to have a recently repaired Tek 2465B calibrated to a hobbyist level. (Blown RIFA caps C1016 and 1018 replaced and R1016 and 1018 replaced. Crystal replaced). Works but calibration error. Voltage measurements not accurate.
I am in the Boston area but could ship.

Title: Re: Calibration wanted for Tektronix 2465B
Post by: tggzzz on April 03, 2025, 08:34:13 pm

The answer is in your other thread.

Hint: don't doublepost; is simply wastes everybody's time

Title: Re: Calibration wanted for Tektronix 2465B
Post by: mariahcarey on June 10, 2025, 08:39:05 am

Quote from: Bosteve on April 03, 2025, 08:01:53 pm

Maybe a long shot, but hoping to have a recently repaired Tek 2465B calibrated to a hobbyist level. (Blown RIFA caps C1016 and 1018 replaced and R1016 and 1018 replaced. Crystal replaced). Works but calibration error. Voltage measurements not accurate.slope (https://slopeio.org)
I am in the Boston area but could ship.

Hey there,
If you're just aiming for hobbyist-level calibration, you might not need a full lab-grade service. Do you have access to any reference voltage sources or a known good DMM? Sometimes just tweaking the voltage calibration against a trusted meter can get you close enough for bench work.