Need help with an lg os-5020 it stopped working(fixed)

[little_carlos]

Hello, so i was using the scope and it was working well, then i switched it off and disconnected the probes, after a while i turned it on, with no probes, and when i hit the switch i heard a pop and now the controls dont work at all
here's a picture of how the screen looks like

i tested the fuse and its allright
i opened the scope and i cant find any burnt component
what can i do?

[little_carlos]

Solved! new record
its the resistor r353, its 2.2 ohm, it was burned, just replace it in case you have the same problem

[SAUL BRITTO]

But you didn't see if the new resistor isn't too hot? It can do the same problem...

[little_carlos]

But you didn't see if the new resistor isn't too hot? It can do the same problem...

no, i leaved it working for an hour and nothing, keeps cold, the new resistor is 2w the old one was 1/2 a watt

[SAUL BRITTO]

Ok but, look at the function of this resistor,maybe a big resistor can't be so good as you think,
put 1/2 watt as the original.