Hi all.
Haven't used my printer for a while, but needed to print something this week.
BLtouch was playing up.
I took it off and replaced the pin
Tested it before i screwed it back in place, worked perfectly, reassembled it, doesn't work.
Long story short, if it's hanging loose, I can move it into any position, twist the wires all over the place etc and it works 100% perfectly.
Within a second of me holding it (by hand) against the bracket I printed for it, it stops working. Can repeat time and time again, it makes no sense.
Can even hold the cables tight in various directions, again it works 100% fine but within a second of me very loosley hoding it against the mounting bracket, it stops working.
Vid attached.
Will probably buy another one as a couple of years ago one of the screw ends snapped off, but still very odd.
https://youtube.com/shorts/eze1DTWEl00?feature=share