« previous next »
Pages: [1]   Go Down

Author Topic: How to add harness entry to existing port  (Read 1575 times)

0 Members and 1 Guest are viewing this topic.

Offline willPowellTopic starter

  • Contributor
  • Posts: 29
  • Country: gb
How to add harness entry to existing port
« on: February 21, 2022, 03:52:39 pm »
Hi everyone,

I am very new to Altium Designer and trying to modify an existing port by adding an additional harness.
Currently Altium displays a red squiggly line when I add a new harness entry. How to add harness entry to existing port?
Please See photo attached

How do I avoid this and how do I sync so that it updates the port on the other schematic?

Thanks in advance,
Will
« Last Edit: February 21, 2022, 04:14:36 pm by willPowell »
Logged
 

Online PlainName

  • Super Contributor
  • ***
  • Posts: 6847
  • Country: va
Re: How to add harness entry to existing port
« Reply #1 on: February 21, 2022, 10:53:48 pm »
Click on the harness body to select it then in the properties panel add the new entry.

Or select Place->Harness->Harness entry :)
« Last Edit: February 21, 2022, 10:55:38 pm by dunkemhigh »
Logged
 
The following users thanked this post: willPowell

Offline willPowellTopic starter

  • Contributor
  • Posts: 29
  • Country: gb
Re: How to add harness entry to existing port
« Reply #2 on: February 22, 2022, 04:28:29 pm »
You're a legend  ;)
Thanks, dunkemhigh
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee