I have a motherboard which clocks in at a very impressive 33" x 17".
Indeed.
Getting the raw card built is no problem. But the smt shop, and the few other smt shops I spoke to, all say it is too big - it won't fit in the smt machine, won't fit into x-ray, won't fit into the reflow oven, and just plain won't fit. Anywhere.
I hate when that happens.
Anyhoo... I want to cut it in half, and slap in some connectors and whatnot to jumper the nets and power that got cut (there aren't that many nets that cross where I want to put the cut line), and then the smtShop can build each half individually. The smtShop will be supplied with the two raw cards, two boms, and two placement files.
But... in altium, I don't want to have two separate designs. I have the great big design already done, including the 33x17" pcbDoc, and I've drawn the line where it'll be cut. So the question:
In Altium: from a single pcbDoc: how do I generate two sets of gerber, two boms, and two placement files?