I just got this meter today.
Bottom line: Excellent. This is the best Chinese brand meter I've gotten from Amazon. I didn't open it up because that's already been done, and the PTCs and MOVs look good.
This thing feels like quality all around. Of course, I didn't take it part and check the rotary switch, or anything like that, but the case is very high quality, high impact, tactile plastic with rubberized grips and rubberized rotary knob. Someone here said they were concerned because someone else said the case isn't built too well. Well, it is--very, very, very well made case. I got no resistance from the leads either. Very nice leads.
It's auto-ranging, so you expect some delay in the current reading, but nope. Quick as shit and same for continuity. I tested it with a 12V strip of 2 SMDs 5050. The calculation for each SMD are between .21 and.24 watts each, or .056 amps for three of them full on @ 12V. the3 meter was dead on, giving my a read out at .061 amps (which is right on for the higher side).
The NCV function is also quality. It's extremely sensitive and goes off immediately from about 4" from a power source.
I'm impressed. It's my new main multimeter for DC work.
REALLY happy after all of the Chinese crap I requested and reviewed. Finally--got a nice clamp meter for DC current and work! Stoked.
It also runs on 2 AAA batts.