Hey
so i’m traying to find a lipo charing / loadsharing circuit that fit’s my needs
My circuit is going to draw around 300-400ma at peak normal / low power mode witch it is going to be for most off the time. Shut end op around 10-50ma.
I’m aming to have around 3-6 18650 lipo battery
http://www.ebay.com/itm/201468564314 in parallel and a setup converter to supply the 5v need
I found this adafruit bord
https://www.adafruit.com/products/2465 witch seems to fit my needs but I’m having trouble scouring it in my country… plus the price is kind of high.
So I’m looking for a new circuit bord that fit the same needs I blog post describing a load sharing circuit
http://blog.zakkemble.co.uk/a-lithium-battery-charger-with-load-sharing/ but as I’m lacking acces to pcb and wut like the bord to be as small as possible
any suggestions where I can find a circuit that fit this needs? Preferably premad so I only need to connect my battery and circuit
Extra question
the adafruit charger is rated at 1000c is this much ore to little for the battery mentioned above ?