Hi
I put a post up about an old Farnell power supply, L30d but as yet no responses.
One question I have, which may help is, I have discovered that one of the large caps has leaked, so I need to replace them.
They are old Hunts caps, which then became erie. I have the circuit diagram for the ps, and can identify them as 2200nf 63 volt high ripple. I can. I assume just replace them, with two 2200nf 63 volts or higher caps. I have found some originals on eBay, but at £14 each, I don't see the point and hopefully can just replace with modern caps. Is that correct, despite there being a massive size difference?
If so, obviously have to remount on something, should I attach them to heat sink, the others, original were not.
Thank you