WTB : Tektronix broken TM module (need the metal case)

[psykok]

Hi,

I have a TM module without case and I'm looking for a broken one or just for the metal enclose to rebuild mine.


ALex

[Stray Electron]

  Not sure which part you need but the plugins for the old Tektronix 5000 series scopes are mostly the same but longer. So many of the small parts will interchange. Walter Shawlee at sphere in Canada had some TM-500 (mechanically) compatible plugins for sale for around $20 a couple of months ago. walter2@sphere.bc.ca

[pamphonica]

Which bits do you need?  I can probably find you the top and bottom pieces plus a metal front-plate from a PG506.  Is that what you need?  I dont have any spare side plates.
Maybe you could send me a PM with details, or photos of what you need.
-Jeremy
(UK)

[Hydron]

I might have some side panels I can spare, but getting from two people is a bit unwieldy especially post-Brexit from the UK - are there no cheap junk modules on ebay?
I got an AM503 for 30 quid just as covid hit, which is probably one of the more useful modules (was expecting a parts unit, but all it needed was a dry joint to be touched up and then was 100% OK, including early-80s electrolytics and wet-slug/dipped tantalums).

[psykok]

Which bits do you need?  I can probably find you the top and bottom pieces plus a metal front-plate from a PG506.  Is that what you need?  I dont have any spare side plates.
Maybe you could send me a PM with details, or photos of what you need.
-Jeremy
(UK)

I need actually  all the side panels (bottom, up, left and right) and also the rails to hold them.
Basically I have only the front panel and all the board for this double  size module.



Alex

[psykok]

I might have some side panels I can spare, but getting from two people is a bit unwieldy especially post-Brexit from the UK - are there no cheap junk modules on ebay?
I got an AM503 for 30 quid just as covid hit, which is probably one of the more useful modules (was expecting a parts unit, but all it needed was a dry joint to be touched up and then was 100% OK, including early-80s electrolytics and wet-slug/dipped tantalums).

You are right, I looking for a cheap junk modules but I haven’t  find anything  jet.


ALex

[kbrill]

If Their is a 3rd party in the US I could send it to I would gladly send you a complete dead or at least economically nonviable single wide plug in or 2 . I would even disassemble and ship the enclosure side panels etc only minus the pull tab cutting the shipping weight substantially . No charge to you except least expensive shipping within US .

Hopefully this does not prove to be your best solution .

Ken