Author Topic: Collision Error  (Read 2794 times)

0 Members and 1 Guest are viewing this topic.

Offline Spark-DoctorTopic starter

  • Contributor
  • Posts: 45
  • Country: gb
Collision Error
« on: February 03, 2024, 01:04:24 pm »
Hi All
I have a mPCIe connector and retainer on the PCB but i wanted to add the module that is going to be used. I created the module in Fusion 360 and imported it into my design successfully but now i get collision errors on the connector and retainer when i position the module. Can i turn off the collision errors some how?????

Edit, sorry i put this post in the wrong group, it should be in the Altium page. Can admins move it?
« Last Edit: February 03, 2024, 01:15:34 pm by Spark-Doctor »
 

Offline thm_w

  • Super Contributor
  • ***
  • Posts: 6711
  • Country: ca
  • Non-expert
Profile -> Modify profile -> Look and Layout ->  Don't show users' signatures
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf