« previous next »
Pages: [1]   Go Down

Author Topic: QucsStudio 4.3.1 - simulation problem  (Read 2376 times)

0 Members and 1 Guest are viewing this topic.

Offline katto01Topic starter

  • Newbie
  • Posts: 3
  • Country: jp
QucsStudio 4.3.1 - simulation problem
« on: November 24, 2023, 02:37:33 pm »
Hello,

I am trying to simulate a simple circuit. I get this warning:
"Ratio of adjiacent grids too large (2.09116) at y=0.0220684mm.
=> Simulation might be innacurate"

Q1: is there a way to modify the mesh in QucsStudio 4.3.1?
Q2: Does QucsStudio 4.3.1 have a dedicated  user forum? I googled it but not found one

Thanks
Logged
 

Offline djsb

  • Frequent Contributor
  • **
  • Posts: 893
  • Country: gb
Re: QucsStudio 4.3.1 - simulation problem
« Reply #1 on: November 24, 2023, 03:30:59 pm »
Forum is here

http://qucsstudio.de/forum-en/

Can't answer the question about grids.
Logged
David
Hertfordshire,UK
University Electronics Technician, London PIC,CCS C,Arduino,Kicad, Altium Designer,LPKF S103,S62 Operator, Electronics instructor. Give a man a fish and you feed him for a day. Teach a man to fish and you feed him for a lifetime. Credited Kicad French to English translator.
 

Offline katto01Topic starter

  • Newbie
  • Posts: 3
  • Country: jp
Re: QucsStudio 4.3.1 - simulation problem
« Reply #2 on: November 24, 2023, 04:00:45 pm »
Thanks

It looks like the forum does not accept new members. Is this right or I have a connetivity issue?
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee