Hi,
I'm looking for software for simulation an electromechanical device. Costs doesn't matter at this point.
The device I would like to simulate a device that looks as follows:
It consists of 4 coils, mounted on a iron plate.
and permanent magnet is mounted on a flexible part close to the coils.
I Would like to use the simulation to optimize the coil spacing and dimensions, coil voltage ect.
Could someone recommend a software suite that is capable of simulation my device.
Tools I could find (but I'm not sure which is best, I have no experience with these tools):
- CST EM studio
- Altair Flux
- EMworks EMS
- Keysight EDMS
Could someone recommend a tool to use?
Best regards Tom