I understand you guys but I cannot do anything about it.
Well, I could, but then I cannot do anymore tests for David or he will have to do some calculations
DL32 is one of my oldest tip and you can be assured it is burned enough
For the past 2-3 years I usually work with 270 and I almost never go over 330, but there are times I also need 380 (which is veeeeeeeery rare).
Before that I used higher temperatures and this tip was also used at higher temperatures and quite a lot so it is well burned.
I will check both resistors to calculate exact gain. Maybe that 1k resistor is lower than what it should be since it has more impact in gain.
Other than that it doesn't matter if I set it to 4095 and use just temperatures to about 380-400 since I will not go over for example "4080".
David, leave FW as it is, it is perfectly fine. If I will decide to do anything about it I will change it for me