Wanted:Working Fluke 8842A option -09

• Wanted:Working Fluke 8842A option -09
  Posted by AB9GO on 13 Mar, 2011 20:26
• Looking for the true RMS option board for my Fluke 8842A.  Looking for the option or a lead where to find one.
  
  Thanks.
  Randy AB9GO
• #1 Reply
  Posted by Simon on 13 Mar, 2011 20:30
• Ebay can turn up some good bargins but general common sense for not getting burnt applies
• #2 Reply
  Posted by AB9GO on 14 Mar, 2011 02:22
• Quote from: Simon on 13 Mar, 2011 20:30

  Ebay can turn up some good bargins but general common sense for not getting burnt applies
  

  
  Nothing much showing up there recently.  Oh well...
  
• #3 Reply
  Posted by mkissin on 14 Mar, 2011 04:54
• I may have one of these. I can't remember if it's for the 8840 or 8842 though. I'll have to check when I get home. IIRC the two should be interchangable, but they have slightly different pinouts on the connector so you'd need to make up a wee adaptor cable.
  
• #4 Reply
  Posted by mkissin on 14 Mar, 2011 07:01
• OK, I've definately have an 8840A-3009, revision M board.
  
  Cosmetically, it's in great condition, but I honestly have no idea if it works or not. I also have schematics for this board and the one you actually want, and can tell you that they are the same except that pins 1 and 8 on the main connector have been transposed (it's a 20-way IDC header).
  
  Send me a PM if you'd like it.
  
• #5 Reply
  Posted by dumpystig on 29 Aug, 2011 18:39
• I realise this is an old topic but I'm looking for the same board. Did you get rid of yours or do you still have it?
• #6 Reply
  Posted by mkissin on 30 Aug, 2011 08:48
• Me? I still have it. Send me a PM if you want it and we can discuss.
• #7 Reply
  Posted by dumpystig on 30 Aug, 2011 09:56
• PM sent