New to the lab is this Keithley DMM7510, a 7 1/2 digit, high performance meter. This beast is amazing!
Here I take a first look at the meter and run a few measurements.
No teardown, since I paid for it!
Great first impression Video, Thank you !
Do you have a stable voltage standard and could see the drift of the 7510 over 24 hours
Would be interesting to see the graph for that.
You need something very stable to see the drift of them 7510.
I compared it to a couple of other meters with a cheap voltage standard:
Reference used:
I finally ran a successful 24 hour test, I'll try to do a longer one some time.
And, here's the setup. If you see anything to improve the tests, please let me know.
I finally ran a successful 24 hour test, I'll try to do a longer one some time.
Thank you!
Very nice, to test it with a SVR-T from Geller.
I have exactly the same Geller voltage reference, so this can be a good comparison to my Keysight 34470A .
What I would like to see is the same test with
100 NPLC setting of the 7510 over 24 hours,
and the range manually set to 10 V, if you can.
Could you also save the data to a csv or excel file?
And, here's the setup. If you see anything to improve the tests, please let me know.
What I noticed in my test's is to keep all RF transmitter and receiver (WiFi, Cell-Phones) far away from the test setup.
Otherwise, was was said already: special low thermal emf leads might be a good investment.
Could you also save the data to a csv or excel file?
+1 .csv or .txt preferred.
Perhaps you can put a cloth over the setup to prevent air currents from creating thermal noise.
With best regards
Andreas
Recently I tested my Geller Labs SVR-T with 3 Agilent meters at the same time in parallel:
2 x Agilent 34461A
1 x Agilent 34470A
Here are the results in comparison after a 4h test.
Manual setting to 10V range
100 NPLC
I am mostly surprised about the small spikes during the test, although everything was far away from any known RF disturbance.
First Agilent 34461A
Second Agilent 34461A
Agilent 34470AWhat I really like about your DMM7510 is that fact, that the standard deviation is shown in its nice units of nV instead of so many zeros. The DMM7510 seems to be a really amazing meter. May be you can produce a few more videos, showing the use of that meter.
What I really like about your DMM7510 is that fact, that the standard deviation is shown in its nice units of nV instead of so many zeros. The DMM7510 seems to be a really amazing meter. May be you can produce a few more videos, showing the use of that meter.
There will definitely be more videos, enough to bore everyone.
Thank you all for the feedback. I'll get some low thermal EMF leads, and do another test when I can. I'll be getting back to some of my low-power measurements, which is why I bought this meter. I look forward to more critiques.
Meanwhile, back to work (day job, every day).