New uRuler

• #150 Reply
  Posted by boshepard69 on 27 Jan, 2020 09:31
• Hey Dave!  Love your videos. I have learned so much watching them.  I used to be a Broadcast TV designer, but now I just work on electronics as a hobby. How do I go about purchasing one of these rulers? 
• #151 Reply
  Posted by EEVblog on 27 Jan, 2020 10:23
• Quote from: boshepard69 on 27 Jan, 2020 09:31

  Hey Dave!  Love your videos. I have learned so much watching them.  I used to be a Broadcast TV designer, but now I just work on electronics as a hobby. How do I go about purchasing one of these rulers?
  

  
  Good question...
  I should get off my arse this year.
  The question is who to use to manufacture them this time around?
• #152 Reply
  Posted by boshepard69 on 27 Jan, 2020 10:26
• Keep up the great work!  Everyone appreciates what you do.
• #153 Reply
  Posted by cj555 on 27 Jan, 2020 15:15
• Ooh yay! I'm setting up my little lab finally, so I'd be glad to pick up a ruler or three.
• #154 Reply
  Posted by scopeman on 07 Feb, 2020 03:01
• Quote from: EEVblog on 27 Jan, 2020 10:23

  Quote from: boshepard69 on 27 Jan, 2020 09:31

  Hey Dave!  Love your videos. I have learned so much watching them.  I used to be a Broadcast TV designer, but now I just work on electronics as a hobby. How do I go about purchasing one of these rulers?
  

  
  Good question...
  I should get off my arse this year.
  The question is who to use to manufacture them this time around?
  

  
  Dave,
  How about making it longer than 12 inches, maybe 15 or 18. Also add the 0.3" spacing for through hole use.
  
  Regards,
  Sam
  W3OHM