Siglent 1052DL+

• Siglent 1052DL+
  Posted by AdrianFu on 03 Aug, 2020 03:22
• Recently I did a firmware update on my 1052 which then upgraded the model to a 1202(?). Not in front of the DSO right now. Not happy with it has it causes the DSO to run slow eg changing voltage level from say 1v/DIV to 10v/DIV can take up to a minute for anything to happen. Is it possible to back pedal back to the original firmware?
  
  Adrian
• #1 Reply
  Posted by tautech on 03 Aug, 2020 03:29
• Quote from: AdrianFu on 03 Aug, 2020 03:22

  Recently I did a firmware update on my 1052 which then upgraded the model to a 1202(?).

  1202(?) ?? 
  Never been such a model.
  Where did you source the firmware from ?
  
  

  Quote

  Not in front of the DSO right now. Not happy with it has it causes the DSO to run slow eg changing voltage level from say 1v/DIV to 10v/DIV can take up to a minute for anything to happen. Is it possible to back pedal back to the original firmware?

  
  SDS1000DL+ firmware page:
  https://int.siglent.com/download/firmwares/?ProId=42
  
  
• #2 Reply
  Posted by AdrianFu on 03 Aug, 2020 07:03
• I downloaded the firmware from that site. This is what happened after updating the firmware.
  
  Adrian

  ---

  
• #3 Reply
  Posted by AdrianFu on 03 Aug, 2020 07:04
• A better picture
  
  Adrian

  ---

  
• #4 Reply
  Posted by tautech on 03 Aug, 2020 07:08
• Quote from: AdrianFu on 03 Aug, 2020 07:04

  A better picture
  
  Adrian
  

  WOW, a 200 MHz DL+ ! 
  
  I'll drop tech support a line for you.
• #5 Reply
  Posted by AdrianFu on 03 Aug, 2020 08:03
• Thanks. Appreciated
  
  Adrian
  
• #6 Reply
  Posted by tv84 on 03 Aug, 2020 08:17
• Quote from: AdrianFu on 03 Aug, 2020 03:22

  Is it possible to back pedal back to the original firmware?
  

  
  If you want to downgrade the BW, send me a pm.
• #7 Reply
  Posted by AdrianFu on 04 Aug, 2020 07:28
• All good thanks TV84. Now (hopefully) back to normal.
  Should have asked the question about the firmware upgrade before I did it
  
  Adrian