And, as usual, without any hints on whats fixed or improved...
And, as usual, without any hints on whats fixed or improved...
Sorry Marty but on P2 of the update instructions "
Solve the problem that stays at the logo interface when booting"
Thanks tautech! But I did not see this information on the european website.
Thanks tautech! But I did not see this information on the european website.
This information is inside upgrade package. There inside update package is pdf how to install update and there read also this information.
Note carefully this special update process. It is not usual one step process. This update need two steps. First intermediate transitory update and after then new FW as described,
Old thread but.. Just had this Happen to my SDM3055..
Sent this to info@siglent.com. Better contact? obviously I can call Monday..
A week or so ago my SMD3055 crashed while in chart mode and I didn’t think anything of it because I was done using it at the time.. I turned it off and that was that.. When I turned it on today, it doesn’t start up. It just stays on the boot screen… then after quite a while goes black, but the screen backlight is on. I’ve read that this is an issue with older firmware and requires it be repair. Hope that isn’t the case because of course I need it to work now!! Because I can’t boot it I don’t know what firmware is on it.. But I know I have updated it since purchase at some point.
Purchased June 27/2016.
Of course this happens on a Friday!!
Old thread but.. Just had this Happen to my SDM3055..
Sent this to info@siglent.com. Better contact? obviously I can call Monday..
A week or so ago my SMD3055 crashed while in chart mode and I didn’t think anything of it because I was done using it at the time.. I turned it off and that was that.. When I turned it on today, it doesn’t start up. It just stays on the boot screen… then after quite a while goes black, but the screen backlight is on. I’ve read that this is an issue with older firmware and requires it be repair. Hope that isn’t the case because of course I need it to work now!! Because I can’t boot it I don’t know what firmware is on it.. But I know I have updated it since purchase at some point.
Purchased June 27/2016.
Of course this happens on a Friday!!
Welcome to the forum.
Steve and his guys in Ohio will sort this for you, the email you've sent will find its way to one of their desks and they'll advise you of the next steps to take.