Just over a 1/4 sheet so clearance on 1200x600. 80-100W is the current plan. Based on this Kiwi design with some tweaks https://www.youtube.com/channel/UCZ72zDm2feverqV7qAbNH7Q/videos The Fusion 360 Plans and materials lists are well worth the few $
It has been tried commercially in one form or another. Unless you want prints running for a week then nozzles in the multiple mm diameter with fat layer lines to match I think going back to other options first would make more sense unless you like the layered thing.
It doesn't get any real direct UV exposure but under load it is subject to Ambient temps regularly 30-40+C.
Well-rated on Amazon; EVERYBODY seems to hate EVERYTHING not ENDER on Amazon
https://www.amazon.ca/gp/product/B07X5TZ7J8/
This should keep me off the streets & out of trouble for a day or three. With the authorities closing events and shops left & right due to the global COVID charlie-foxtrot, the wife is ALREADY ready to break my foot off in my own ass... All 3 of her children have been driving her batty for a week now.
Selling points:
Cheap as chips, PLUS $40 off; PRIME delivery
32-bit Board, Trinamic 2208s, 4.3" Touchscreen
Glass upgraded, heated bed w/oversized knibberty-knobs
Proper IEC Power
EOF Sensor, Print Resume Marlin FW
Well-rated on Amazon; EVERYBODY seems to hate EVERYTHING not ENDER on Amazon
Kit form, and probably a POS... so should keep me busy for a while fixing all the little "stoopit shit" things.
I toyed with getting this franchise-builder Ender 3: https://www.amazon.ca/dp/B07P68LDLG/ but wasn't convinced it was all CREALITY quality. I'll probably regret it...
mnem
Good thing I have a Dremel...
Well-rated on Amazon; EVERYBODY seems to hate EVERYTHING not ENDER on Amazon
Yea, but that thing isn't an Ender ...
It'll probably be OK if the aluminum was cut accurately. Keep a fire extinguisher handy and keep us informed.
Got some nice features for the price. With the two fairly independent side beams I would double check and shim if needed whatever desk or bench you finish up using it on to make sure all four feet are co-planer otherwise we await the results. Welcome back to the world of 3DP.
I've got a CNC dual-gear-drive extruder (supposedly the schizz for NinjaFlex, etc) on the way, along with a V6 hotend/SS tube and some silicone hotend socks. When I get a little further on the project, I'll post some more pics.
When new firmware is released where can we find them? I haven't been able to find a website for this printer
Answer:
This printer is a rebadged Alfawise U30 Pro/Longer LK4 Pro, and it is running modded Marlin 1.1.9. In Cura the Alphawise U30 dropdown works perfect. Looking up information under Longer LK4 Pro seems more available.