Hi,
I have this connector, that i'm unable to identify. (Sorry phone image)
Widht: 16 mm. Height: 5 mm. Pin spacing C-C 5 mm. The pins themselves looks like regular spade connector, but i'm unable to find those, they measure 4x2,2 mm
If it can be of any help, it's to a Massey Ferguson 4900 rear lift controller, looks like it is made by Bosch.
I might have seen this before in (high school) robotics. I didn't measure them, I just help the kids solder the other end. Might have - it was a few years ago so I am not dead-certain.
Try that arena, may be you'll get lucky.
Thanks for the hint. I'll continue to google. I've done it for hours now.
The liftsensor has a Bosch PN 0 538 001 102, which gives nothing on google.