Sourcing?? 1.0mm Pitch Board to Board 100 Pin Connectors Or Headers Source.

• Sourcing?? 1.0mm Pitch Board to Board 100 Pin Connectors Or Headers Source.
  Posted by KG7AMV on 04 Mar, 2024 16:29
• I am trying to source a replacement Board to board connector for the Oupiin 2348-100G00DP1T Board to Board Mezzanine Connector. Mfg Says Discontinued.
  
  Data Sheet..
  https://www.oupiin.com/download.html?act=gTData&dID=4146
  
  Photo
  
  
  I did find one supplier that claimed they had https://www.dghecon.com/productinfo/2190163.html after discussion they did not have the mold for 100pin only 80 ughhh.
  
  Alternative would be to replace the Oupiin Connectors and use headers. They use them in the Board stack but cannot seem to find the source for like kind either. I have looked very close at the Header connector no mfg markings and Stack height needs to be 8mm.
  
  Anyone? ID These Headers?
  Male
  
  Female
  
  
   Thanks.
  
• #1 Reply
  Posted by thm_w on 05 Mar, 2024 22:19
• Your post for reference: https://www.stevenrhine.com/?p=130422
  
  Have you checked that just standard 1mm SMD headers will not fit the footprint?
  https://www.aliexpress.us/item/3256805788002696.html
• #2 Reply
  Posted by EPAIII on 06 Mar, 2024 10:30
• Two 50 pins and a few minutes work with a Dremel.
  
  Align them for soldering with a couple of lengths of the pin headers suggested by thm_w.
• #3 Reply
  Posted by tooki on 06 Mar, 2024 22:32
• Would one of Samtec’s 1.0mm pitch headers work? They claim to have up to 100 position models.