PCB Designer for sensor board with 4-20ma output

• PCB Designer for sensor board with 4-20ma output
  Posted by pcbsensor on 23 Apr, 2024 15:20
• Hello,
  
  I'm seeking a PCB designer to help with a brand new project to convert a voltage signal coming from a sensor into a proportional 4-20ma output. 
  The PCB will be used in an industrial application.
  
  The candidate should have knowledge of analog and digital circuits, power protection of the circuit, voltage step down and ideally have worked with integrating sensors in the past.
  
  PM or e-mail me with your portfolio, CV or resume.  Also send your hourly rate, location and availability.
  
  I look forward to speaking!
  
  Thanks!
• #1 Reply
  Posted by alpelectronics on 23 Apr, 2024 15:35
• Pm sent.
• #2 Reply
  Posted by quince on 01 May, 2024 06:02
• This is a ridiculous project to post given that you can literally buy it on Amazon: https://www.amazon.com/Current-Voltage-Converter-Module-Non-Isolated/dp/B07VTRVD75
  
  If you are just trying to harvest CVs, try a little harder.