I have received parts for a small project that I haven't found realized in the way that I am attempting it. For today, just a picture. That AWG8 cable assembly took me two hours to finish
Any creative idea of what this is going to become in the end?
2nd Guess: Remote voltage sensing also incorporating a fused power connection.
Depends... what is that black brick?
if it's a FET... coilgun!
Some sort of payback device for a Neighbors From Hell electrical switchboard ?
You using a PMSM servo motor, at 2,000 Watts (we are!), to stack an extra third road traffic cone, on top of two nicely stacked on top of each other ?
A very-rugged armband for your smartphone ?
48V, 40 Amp, Connector to a/the Motor (controller elsewhere), 2,000 Watt. With directional control, the black, four terminal block being some kind of powerful diode block/pack.
To me it looks like a hookup for a power meter, but that is not a creative idea on my part : (
Remote switch off.
Two pin power connector tester, because that looks like it would be the first part to blow!
A solar battery charger/inverter switch.
I think I would be using anderson power poles instead of RC car connectors.
And 2 hours??? How?
You using a PMSM servo motor, at 2,000 Watts (we are!), to stack an extra third road traffic cone, on top of two nicely stacked on top of each other ?
you're well informed, but not even close
edit: except for one part: resistance is supposed to be futile in this case as well
I think I would be using anderson power poles instead of RC car connectors.
And 2 hours??? How?
The connector
scares worries me a bit too, but the counterpart is already there...
2 hours?
You're fired!
I should have quit that job because of poor working conditions! The crimp tool didn't take the AWG8 without adding a hammer, the soldering iron didn't like that cross section either, and where's my electronics side cutter???
*cough* almost forgot that my boss is again me in this case
At least I am happy that I have found a proper space for my hobby now
Run isolator for charging your electric scooter conversion.
spoiler alert: the correct anwer was already given