-
Proteus ARES PCB - How to wire a link pad to some component pad.
Posted by Oshio on 07 Jan, 2018 21:53 -
I'm designing a single side pcb, due to trail's density, I decided to use link wires in order to avoid overlap, but when I started routing, the software didn't allow me to connect any wire to link's pad. I tried to assign some netclass but couldn't find a way to that. Sometimes, only by luck, I successfully make the connection, but I'm clueless about what made it possible. I attached a picture that illustrates both situations.
I'm using Proteus 8.6 SP2.